Swiftech MCR120 F Manuel d'utilisateur télécharger pdf

Packing list

MCR120 radiator 1 Tube inserts 2

Snap-rivet 4 120x25mm fan 1

6-32” x 3/8” Philips screw 4 Quick-connect fittings 2

Back

Chassis

Snap-rivet

120mm fan

MCR120 Radiator

6-32 x 3/8" philips

Figure 1

Front

Chassis

Snap-rivet

6-32 x 3/8" philips

MCR120 radiator

120mm fan

Figure 2

Preamble

The MCR120-F ships with the fan pre-assembled to the radiator. It has been configured so that the fan will draw fresh air from outside of the chassis.

This configuration is preferred to optimize cooling of the CPU. In effect, if the fan flow direction were reversed, it would use heated air inside of the

chassis, which is usually 3°C (at best) and up to 10°C hotter than that of the ambient air outside of the chassis.

1. Installation

Depending where a 120mm fan opening is available, the MCR120-F can be installed as shown in Figure 1 (back of the chassis), or Figure 2 (front of

the chassis). Due to the wide variety of chassis configurations, Swiftech cannot guarantee that this assembly will bolt into any chassis without some

modifications. However, an external mounting solution is optionally available with the MCB120

“Radbox” which will usually allow a plug-and-play

installation with most desktop computers.

2. Bleeding

For bleeding purposes, the preferred radiator orientation is with inlet and outlet pointing up as shown above. Nonetheless, the radiator can also be

installed at 90° or 180°. In such cases, simply rotate the radiator back upwards to allow the air trapped inside to escape during the filling and bleeding

process. For this reason, it might be more convenient to fasten the radiator to the chassis after the circuit has been fully filled and bled.

3. Using quick-connect fittings

If you are using soft vinyl tubing, you must also use the provided tube

inserts. Cut the extremity of the tube squarely, and fully engage the tube

insert into the tube as shown in Figure 3.

Figure 3

Page 1 of 2

Rouchon Industries, Inc., dbA Swiftech™ – 1703 E. 28

St, signal Hill, CA 90755, USA – T (562) 595-8009 – F (562) 595-8769 – All content Copyright

Swiftech 2004 – Last edited 7-31-04 – Subject to revision without notice

1 2

Figure 3 1

Résumé du contenu

Page 1 - Figure 3

Packing list MCR120 radiator 1 Tube inserts 2 Snap-rivet 4 120x25mm fan 1 6-32” x 3/8” Philips screw 4 Quick-connect fittings 2 BackofChass

Page 2

4. Tube insertion TIP! Rubbing the extremity of the tube with a little bit of liquid soap will greatly facilitate insertion of the tube into the qu

Commentaires sur ces manuels

Pas de commentaire

Swiftech MCR120 F Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Accessoires pour ordinateurs Swiftech MCR120 F. Swiftech MCR120 F User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires pour ordinateurs Swiftech MCR120 F