Swiftech MCX159 R Manuel d'utilisateur télécharger pdf

Rouchon Industries, Inc., dba Swiftech – 1703 E. 28

Street, Signal Hill, CA 90755 – Tel. 562-595-8009 – Fax 562-595-8769

E Mail: Swiftech @swiftnets.com – URL: http://www.swiftnets.com

Page 1

2. Heatsink fan installation for AMD platforms

 Remove the fan by unscrewing the two Philips screws.

 Disengage the wire spring from the center row of pins by

alternatively pulling up one side at a time as shown to the

right:

 Install the retention brackets, by sliding them down over the

two corner pins adjacent to the most widely spaced

diagonal 4-40 holes as shown Figure 5 page 2.

Figure 3

Pull-up…

Figure 4

..Then rotate the heatsink and

pull-up the other side

Packing list

Parts Qty Parts specific to AMD installations Qty Parts specific to AMD installations Qty

Heat Sink 1 AMD Brackets 2 Black fiber washers 6

40mm fan & screws 1 4-40 x 3/16” socket screws 2 4-40 mini-nuts 2

Wire-Spring – PRE-INSTALLED 1 4-40 x 1 ¼” Philips screws 2 Knurled knobs 2

Thermal grease – Arctic Alumina 1 Nylon tensions limiters 2 Springs 2

Neoprene pads (strip of 4) 1 Hex wrench 1

CAUTION!

The MCX159-R as shipped is configured for direct installation to Intel



platforms. For installation with AMD



platforms,

an adapter kit is provided and necessitates removal of the pre-installed wire spring. See chapter 2 for details.

1. Heatsink fan Installation for Intel Platforms

 Installation does not necessitate removal of the motherboard from the chassis.

 Remove the existing heatsink and carefully clean the microprocessor with alcohol

 Lightly coat the processor core with the provided Arctic Alumina thermal compound. Only a paper-thin coat is necessary! It

should be applied using preferably a razor blade, or a credit card, held between thumb and index at a 45° angle.

Figure 1

 Install the provided neoprene pads

onto the processor as shown above

Figure 2

 Install the heatsink fan onto the processor as shown above by simply engaging one end of the

hook into a motherboard retention loop then engaging the opposite hook. Make sure that the

heatsink is centered between the two arms of the wire-spring.

 Connect the fan to any motherboard 3-pin power connector.

Installation is complete!

Information subject to change without notice

1 2

Installation is complete! 2

Résumé du contenu

Page 1

Page 2 - Installation is complete!

4-40 x 2 1/4" philips screwFa nKnurled knobSp rin gte n s io n lim it e rflange facing down4-40 x 3/16" socket screwbracket: slide bracke

Plus de documents pour Accessoires pour ordinateurs Swiftech MCX159 R

Voir le document Swiftech MCX159 R Manuel d'utilisateur

Swiftech MCX159 R Manuel d'utilisateur (3 pages)

Commentaires sur ces manuels

Pas de commentaire

Swiftech MCX159 R Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Accessoires pour ordinateurs Swiftech MCX159 R. Swiftech MCX159 R User Manual [en] Manuel d'utilisatio

Résumé du contenu

Plus de documents pour Accessoires pour ordinateurs Swiftech MCX159 R

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires pour ordinateurs Swiftech MCX159 R