Swiftech H20 220 APEX ULTRA REV2 Manuel d'utilisateur télécharger pdf (Page 16)

Rouchon Industries, Inc., dba Swiftech – 3700 Industry Avenue, Suite 104, Lakewood, CA 90712 – Toll free (US) 888-857-9438 – Fax 562-595-8769 - E Mail:

[email protected]

PAGE 16 of 24

3. R

INSTALLING THE MOTHERBOARD

Now that the APOGEE water-block is securely fastened to the motherboard, go-ahead and install the motherboard into the chassis,

following the instructions provided in your motherboard installation guide.

4. P

UMP INSTALLATION

Error! 

 General Use

The MCP655-B pump is a magnetically driven

centrifugal pump featuring a 12 V DC motor. It

requires no maintenance when used with de-

mineralized water and the appropriate anti-fungal

additives. We recommend using 5% Swiftech’s

HydrX as an additive. The pump is designed to be

connected to your computer power supply using the

standard Molex 4 pin connectors.

The MCP655-B pump is neither submersible, nor

self- priming. The inlet needs to be continuously

supplied with fluid for the pump to operate properly.

 Physical installation

 Determine the best location for your pump by

observing how the tubing will be routed to the

rest of the circuit. Sharp bends in the tubing

should always be avoided to prevent kinks,

which will reduce or completely prevent flow of

the cooling fluid.

 In general, we recommend installation of the

pump at the bottom of the chassis.

 The base of the pump features a soft

neoprene pad coated with strong adhesive

material. Once the final location for the pump

has been determined, simply peel-off the

pad’s protective paper, and press the pump

against the chassis surface. The surface

should be clean, and non greasy. Thru-bolts

are also provided for permanent installation,

and require drilling holes in the chassis.

 Pump operating

precautions:

The MCP655-B pump should never be run dry,

even for a quick test. You should always prime

the pump with fluid before you start operating it

(see warranty note *).

Use of coloring die or fluorescent additives

containing particulate fillers will cause excessive

wear to the pump’s impeller bearing (see warranty

note **).

Note 1: Always make sure to directly connect the RESERVOIR DISCHARGE to

the PUMP INLET.

Note 2: Please read important preamble in paragraph 5 below “Preparing the

Tubing” prior to installing the tubing to your pump.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Commentaires sur ces manuels

Pas de commentaire

Swiftech H20 220 APEX ULTRA REV2 Manuel d'utilisateur Page 16

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires pour ordinateurs Swiftech H20 220 APEX ULTRA REV2