Swiftech MCW5000 P Manuel d'utilisateur télécharger pdf

Swiftech Inc., 1703 E. 28

St., Signal Hill, CA 90755 T. (562) 595-8009 F. (562) 595-8769

Page 1 of 2

Parts list

Parts QTY PARTS QTY

MCW5000-P™ assembly 1 Spring clips 2

Tube inserts 4 Arctic Alumina Thermal compound 1

Tube removal tool 1 Hex L-key 1

This product is intended for expert users. Please consult with a qualified technician for installation. Improper installation may result in damage

to your components. Swiftech assumes no liability whatsoever, expressed or implied, for the use of these products, nor their installation. The

following instructions are subject to change without notice. Please visit our web site at www.swiftnets.com

for updates.

1. Before you install the MCW5000-P™ water-block:

a. Prepare two pieces of tubing of sufficient length to connect

to the rest of your circuit. The cuts must be square as shown in

figure 1 or leaks may occur:

b. Install the provided plastic tube inserts at each end of the tubes,

as shown in figure 2: these inserts are absolutely imperative when

using any kind of soft tubing, such as vynil, ClearFlex, Taigon, etc...

Square cut

Figure 1

Figure 2

Figure 3

Figure 4

Figure 5

c. Spread a little bit of grease (Vaseline etc..)

around the tubing. It helps pushing the tubes in,

particularly with Clearflex tubing, which

features a very “sticky” surface.

d. Fully insert both tubes into the fittings. The tip of the plastic tube inserts should

be flush with the inlet and outlet openings, as shown in figure 4 above. Inserting the

tubes requires a firm push, accompanied by a twisting motion.

Block orientation (rotating the stainless steel frame to change the inlet/outlet orientation):

The MCW5000™ can be installed in any direction that suits your needs.

Removing the 4 socket screws that attach the frame to the block will allow

you to rotate the frame 90°, so that inlet and outlet face up and down

instead of left and right. This doesn’t affect the performance of the block,

nor the ability to bleed it appropriately.

1 2

Résumé du contenu

Page 1 - Parts list

Swiftech Inc., 1703 E. 28th St., Signal Hill, CA 90755 T. (562) 595-8009 F. (562) 595-8769 Page 1 of 2 Parts list Parts QTY PARTS QTY MCW5000-

Page 2 - Swiftech Inc., 1703 E. 28

Swiftech Inc., 1703 E. 28th St., Signal Hill, CA 90755 T. (562) 595-8009 F. (562) 595-8769 Page 2 of 2 2. Preparing your Motherboard a. Remo

Commentaires sur ces manuels

Pas de commentaire

Swiftech MCW5000 P Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Accessoires pour ordinateurs Swiftech MCW5000 P. Swiftech MCW5000 P User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires pour ordinateurs Swiftech MCW5000 P